|
|
|
FT3000 (N440BX motherboard)
- Motherboard Jumpers
Jumper Block |
Pins
(default-bold) |
What it does at system reset |
A |
BMC Forced Update Mode |
9-10, Normal |
System boots normally |
10-11, Program |
System tries to update BMC firmware. |
B |
Chassis Intrusion Detection |
5-6, Enable |
Switch installed on chassis indicates
when cover has been removed. |
6-7, Disable |
Chassis intrusion switch is bypassed. |
C |
FRB Timer Enable |
1-2, Enable |
FRB operation is enabled (system boots
from processor 1 if processor 0 fails). |
2-3, Disable |
FRB is disabled. |
D |
Boot Block Write Protect |
13-14, Protect |
BIOS boot block is write-protected. |
14-15 Erase/Program |
BIOS boot block is erasable and
programmable. |
E |
Recovery Boot |
9-10, Normal |
System attempts to boot using the BIOS
stored in flash memory. |
10-11, Recovery |
BIOS attempts a recovery boot, loading
BIOS code from a floppy diskette into the flash device. This is typically used when the
BIOS code has been corrupted. |
F |
Password clear |
5-6, Protect |
Maintains the current system password. |
6-7, Erase |
Clears the password. |
G |
CMOS clear |
1-2, Protect |
Preserves the contents of NVRAM. |
2-3, Erase |
Replaces the contents of NVRAM with the
manufacturing default settings. |
H |
BMC boot block write protect |
1-2, Protect |
BMC boot block is wrote protected. |
2-3, Erase/Program |
BMC boot block is erasable and
programmable. |
I |
WOL Enable |
1-2, Disabled |
Disables Wake On LAN. If your power
supply does not provide 0.8 A of +5 V Standby current, you must move the WOL Enable jumper
to this position. |
2-3, Enabled |
Enables Wake On LAN |
|
|