|
|
|
|
|
                   |
|
 |
|
If opening the Motherboard side, be sure to switch the machine to Standby Mode. After it has powered down, set the UPS isolator switch on the back panel of the Shogun to OFF and unplug the mains power cable.
To remove the side panel:
1. Loosen the floating fasteners, located at the top left and right corners of the panel, until they move in and out freely. These fasteners are mounted in a spring fitting and should not be separated from the panel.
2. Insert the side panel key into the keylock and turn it ¼ turn clockwise to unlock the panel. Your system is equipped with one pair of side panel keys which are unique to your machine. Both keys in the pair will unlock both side panels.
3. Lift the side panel outward and upward as shown:
Refitting the Side Panel
Use the following steps to refit the side panel:
1. Ensure that the lip on the inner surface of the side panel fits over the chassis ridge.
2. Fit the panel snugly into place.
3. Tighten the floating fasteners.
4. Insert the side panel key into the lock and turn it clockwise as far as it will go.
5. Push the lock inward until you feel the resistance of the metalwork.
6. Turn the lock ¼ turn anti-clockwise and remove the key.
