Known Problems with the Feature Card Installed in
XEN-PCLS
System Hanging after Re-boot
The hanging after Windows Setup re-boot on A1 systems noted in the
Engineering Approval report appears to be an intermittent problem, so far reported on only
one system (DX2-66): a number of other A1 systems were tested and all worked OK. If the
problem does happen, powering down and up clears the fault and there is no loss of data.
Security Beep Not Working Properly
The noise reported when the Security sub-system acknowledges an IR card
signal on Revenge based products (RBxxxxx) is a feature! The software was run as an
".EXE" after DOS had loaded and it correctly 'beeped'. The conclusion is the
motherboard BIOS does not complete the hardware setup/configuration until after any
'option ROM code' has been executed, therefore there is very little that can be done. |
