SCO TCP/IP 1.1.3f with on-board Ethernet
When using the latest release of SCO TCP/IP (release 1.1.3f) on systems
with on-board Ethernet, the Apricot LLI Driver must be release 3.0.(Latest version at time
of writing).
This driver is on the bulletin board in area 39 as the file LLI300.Z
The procedure for installing this version of the driver has changed from
older versions, and is outlined below:-
- If upgrading the driver already installed, use custom to remove the
existing driver. Manually remove the perms file, /etc/perms/e592.
- Use custom to install the rel.3 driver software.
- Run the command "mkdev e5920". Select "e592". If
there is a clash of Interrupt vectors, then edit /etc/conf/cf.d/mdevice, and change the
number at the end of the line for "wdha" from 6 to -1 as detailed in IPB 3087.
- Run the command "mkdev e5920tcp". This configures the TCP/IP
software's Internet address, net mask, and broadcast address.
- Reboot the system and test by using the command "ping remote",
where "remote" is a hostname defined in /etc/hosts.
----------oOo---------- |
